Product added to your wishlist! View wishlist
Sign in to see your saved products on any device
Product removed from your wishlist! View wishlist
Sign in to see your saved products on any device
Something went wrong. Please try again later.
Product is added to compare already. Please refresh the page.
Product is not found in compare. Please refresh the page.
5 Products already added. Please delete existing selection to add this.
Share this product
SunStar Heating Products Infrared Ceramic Heater, Propane, 104,000 BTU, Model# SGM10-L1
This product ad may change over time
ShareSunStar Heating Products Infrared Ceramic Heater, Propane, 104,000 BTU, Model# SGM10-L1
The SunStar Heating Products Ceramic Heater is ideal for spot heating or area heating of remote locations, farm buildings, shops, service areas, pump houses or other hard-to-heat spaces, providing both fuel efficiency of radiant heat and installation flexibility (not recommended for car washes). This is a Millivolt Standing Pilot heater and does not requi…
The SunStar Heating Products Ceramic Heater is ideal for spot heating or area heating of remote locations, farm buildings, shops, service areas, pump houses or other hard-to-heat spaces, providing both fuel efficiency of radiant heat and installation flexibility (not recommended for car washes). This is a Millivolt Standing Pilot heater and does not require an external power or electricity to operate, so it's great for use during power outages. Requires Millivolt thermostat for SGM (sold separately). May require the following second stage regulators prior to the heater based on gas supply pressure: A regulator up to 2 PSIG line pressure or a regulator above 2 PSIG line pressure (both sold separately). NOT CERTIFIED OR APPROVED FOR RESIDENTIAL USE. Indoor use only. U.S.A. NOTE: Please review the detailed Installation & Operating Instructions (attached) for other specific installation requirements (gas pressure, ventilation etc) prior to purchasing the heater. Constructed from aluminized steel for corrosion resistance and long life Aluminum reflectors are designed to maximize radiant output Heaters can be angled mounted horizontal and up to 45 degrees The minimum mounting height is 15ft. above finished floor for uniform energy distribution and human comfort Requires the following clearances from any combustible material: 36in. above, 96in. below and 45in. from the sides of the heater The minimum supply gas pressure is 11.0in. Water Column (WC) and the maximum supply pressure is 14in. WC gas pressure If higher gas pressure is supplied, you will need to install a line pressure regulator (sold separately) to reduce it to less than 14in. WC (or 1/2 PSIG) Supply pressure of 11in. WC is critical and supply pressure less than 11in. WC can affect the operation of the pilot/heater The standing pilot flame can be affected in windy/drafted areas and not recommended in these environments No assembly required Heaters are 100% test-fired prior to shipment CSA design certified
Description
The SunStar Heating Products Ceramic Heater is ideal for spot heating or area heating of remote locations, farm buildings, shops, service areas, pump houses or other hard-to-heat spaces, providing both fuel efficiency of radiant heat and installation flexibility (not recommended for car washes). This is a Millivolt Standing Pilot heater and does not require an external power or electricity to operate, so it's great for use during power outages. Requires Millivolt thermostat for SGM (sold separately). May require the following second stage regulators prior to the heater based on gas supply pressure: A regulator up to 2 PSIG line pressure or a regulator above 2 PSIG line pressure (both sold separately). NOT CERTIFIED OR APPROVED FOR RESIDENTIAL USE. Indoor use only. U.S.A. NOTE: Please review the detailed Installation & Operating Instructions (attached) for other specific installation requirements (gas pressure, ventilation etc) prior to purchasing the heater. Constructed from aluminized steel for corrosion resistance and long life Aluminum reflectors are designed to maximize radiant output Heaters can be angled mounted horizontal and up to 45 degrees The minimum mounting height is 15ft. above finished floor for uniform energy distribution and human comfort Requires the following clearances from any combustible material: 36in. above, 96in. below and 45in. from the sides of the heater The minimum supply gas pressure is 11.0in. Water Column (WC) and the maximum supply pressure is 14in. WC gas pressure If higher gas pressure is supplied, you will need to install a line pressure regulator (sold separately) to reduce it to less than 14in. WC (or 1/2 PSIG) Supply pressure of 11in. WC is critical and supply pressure less than 11in. WC can affect the operation of the pilot/heater The standing pilot flame can be affected in windy/drafted areas and not recommended in these environments No assembly required Heaters are 100% test-fired prior to shipment CSA design certified
Specifications
| Brand | Sunstar Heating Products |
| Item Model Number | Sgm10-l1 |
| Manufacturer: | Sunstar Heating Products |