About 85% of this first Terran 1 rocket was 3D-printed. Relativity prices Terran 1 at $12 million per launch. It's designed to carry about 1,250 kilograms to low Earth orbit. That puts Terran 1 in ...

The world’s first 3D-printed rocket made it off the launch pad Wednesday night but failed to reach orbit in a key test flight by a California-based aerospace startup. Relativity Space’s Terran ...

An almost fully 3D-printed rocket lifted off from Cape Canaveral on Wednesday evening, but ultimately failed to reach orbit. Despite this, the Terran-1 passed key objectives and showed the ...

Launch startup Relativity Space Inc’s mostly 3D-printed Terran 1 rocket failed to reach orbit after suffering an issue mid-flight. After successfully launching from Cape Canaveral, Florida on ...

This came in August 1998, when a Paektusan-1 rocket – often known in the West as Taepodong-1 – was used to loft Kwangmyŏngsŏng-1. This failed to reach orbit due to a third stage malfunction ...

With this $140 million funding round, Relativity is fully funded to become the first company in the world to launch an entirely 3D printed rocket to orbit and enter commercial service in early 2021.

3D printing for rocket engines is making a lot of headlines lately. In the last few weeks, we've told you about Aerojet Rocketdyne building and hot-firing a 3D-printed rocket engine ... Dragon ...

There's nothing innate about the Earth or its atmosphere that marks the boundaries of low Earth orbit. This is a distinction ...

We can make our 3D-printed parts even more capable when we start mixing them with some essential “mechanical vitamins.” By combining prints with screws, nuts, fasteners, and pins, we get a ...

An almost fully 3D-printed rocket lifted off from Cape Canaveral on Wednesday evening, but ultimately failed to reach orbit. Despite this, the Terran-1 passed key objectives and showed the ...

Greenville City Council on Tuesday approved the Recreation and Parks Department's master plan. The plan lays out some goals and objectives for the department during the next 10 years. Erin Jenkins ...

The second stage should then have taken over to complete the journey to orbit but, after a few flickers ... was to have more than 95% of the rocket 3D printed. 3D printing is when a physical ...